簡紹6噸燒水鍋爐風機停爐有效性清潔的方法
This paper introduces the method of effective maintenance of 6 tons hot water boilers
根據
6噸熱開水蒸汽鍋爐系統故障甚至停水的現象加熱爐要有停爐，水汽加熱爐停前面須得關閉加熱爐的燒燃，漸漸地的下降加熱爐的的溫度隨后高于加熱爐不各種壓力，停爐前面要把自吸水泵、鼓軸流風扇和引軸流風扇取消。
Need to stop because of boiler failure or outage boiler furnace, steam boiler stop should stop before the boiler combustion, slowly until the lower the temperature of the boiler is up to no pressure boiler, boiler stop before to turn off the water pump, fan and induced draft fan.
工業加熱爐燃燒停爐后的運營怡養，分成爐身離體部和鍋內的玻璃鋼防水涂料怡養。鍋內的玻璃鋼防水涂料怡養，理論依據停爐耗時的時間長短的選擇干法怡養和濕法怡養有兩種。在工業加熱爐燃燒長時禁用時，應很主意爐身離體部的玻璃鋼防水涂料怡養情況。第一個在工業加熱爐燃燒停爐蒸發后，必不可少盡量用一些充分肅清熱膨脹面的漏灰和爐排上方、爐體下端的灰渣。后來要保證排煙管道還有一個定的自然美補風。通常情況下，方便隔潮應在爐膛、排煙管道內加置無趣劑。After the boiler is stopped, the maintenance of the summer is divided into the outside of the furnace and the inside of the pot. The inside of the pot is embalmed, according to the length of the pit stop time and the way of the summer and wet summer. When the boiler is discontinued for a long time, it is important to keep an eye on the embalming problem of the outside of the furnace. First, after the boiler is cooled, it is necessary to completely clean up the ashes of the heating surface and the top of the grate and the ashes of the lower part of the furnace. Then stick to the flue and have certain natural ventilation. In normal condition, to prevent the moisture from the furnace, the flue should be placed in the fire. If lime is used as a dry agent, it should be placed at about 3kg per cubic meter of furnace or flue. When placed, close all ventilation doors tightly. The powdered lime should be changed.
如煤氣燃氣鍋爐風機房地理位置低洼地區，停爐期間里半空中泛潮嚴重的時，則應通過常常文火烘烤和移動到空調劑相隔離的方式方法。例如煤氣燃氣鍋爐風機煤氣燃氣鍋爐風機時間段挺長，在徹底消除肅清煙灰后在爐體塑料表面能面涂以紅丹油或一些防腐處理漆。
If the boiler room is low, and the air tide is severe during the stop furnace, it should be used in the method of baking and placing the dry agent. If boiler time is very long, after thorough purging ash, the surface of the furnace metal surface is coated with red Dan oil or other anticorrosion paint.
置于爐自身部停爐的玻璃鋼防腐怡養有效的方法，則要按停爐時間的快慢來確定。一般條件下，停爐不趕超一兩十半三個月的可以用濕法怡養，一兩十半三個月之內的應采用干法怡養。
As to the preservation of the furnace inside the furnace, it is determined by the length of the stop furnace. In ordinary condition, stop furnace is not exceed a month of usable wet law to be raised, more than a month should adopt dry law to be taken care of.
干法怡養時要關注下列幾號毛病：空調劑不想會直接沾染煤氣鍋爐復合表層，可裝在鐵盤等玻璃容器內;放入空調劑后，要關嚴手孔和其它的孔蓋，汽、自來水管道上的電動閥門必需品剪斷;石灰粉石變粉應即使改換。
When you do the work, you should pay attention to the following questions: the dry agent should not be directly exposed to the metal surface of the boiler, but it can be installed in the iron tray and other containers. After the boring agent is placed, the valve must be cut off for the hole and other holes. The powdered lime should be changed in time.
